Enter the DIP Switch sequence (Use ONLY 1 and 0).Set Linear Multi-Code frequency and encryption: Press 03 # 4 #.Enter program mode: * (Master Code) #.Write the DIP switch 10-digit sequence: _ NOTE: Leave any unused switch locations blank. If DIP switch is in the “up” or “on” (CLOSED) position place a 1, “down” or “off” (OPEN) position place a 0 in the corresponding box in the chart below.ĭIP Switch Sequence| 1| 2| 3| 4| 5| 6| 7| 8| 9| 10 Locate the DIP switch sequence on the operator and record it.
Within 30 seconds – Enter a valid 4-digit PIN then press #. To reset factory default – Press 03 # 1 #.LiftMaster Security+ 390 MHz – Press 03 # 3 #.LiftMaster Security+ 315 MHz – Press 03 # 2 #.Set frequency and encryption (KPW250 only): Proceedįor LiftMaster Security+ (315 MHz or 390 MHz), the frequency and encryption LiftMaster Security+ 2.0 (tri-band 310, 315, and 390 MHz) operators. KPW250 – The frequency and encryption are set at the factory for KPW5 – The frequency and encryption are set at the factory. NOTE: The Master Code and a PIN need to be set before the gate operatorĬan be programmed. Or if user tries to program a PIN already programmed in the memory. NOTE: An error tone will sound if the maximum number of PINs is exceeded
Exit Program Mode| #| Keypad backlight will turn offĠ1 # (New 4-digit PIN) # Repeat (new 4-digit PIN) # Recommended to change and record your unique Master Code.Ġ9 # (New 6-digit Code) # (New 6-digit Code) #ģ. A Master Code is required (factoryĭefault code: 888888) to operate the Wireless Commercial Keypad. Prevent unauthorized access to the system. The keypad will exit the programming mode. The keypad will remain in programming mode. Programming mode, if an invalid code is entered, an error tone will sound, but The keypadīacklight will remain on if the product is in programming mode. Of the programming steps below unless otherwise indicated. The Wireless Commercial Keypad must be put into programming mode prior to any
KPW250| LiftMaster Security+ 2.0® Default The Wireless Commercial Keypad is compatible with the brands of commercialĭoor and gate operators listed in the table below. Invalid PIN or partial PIN is accidentally entered, an error tone will sound. The keypadīacklight will illuminate for 15 seconds when any key is pressed. A wireless signal is transmitted when a validĤ-digit PIN and the # key is pressed. The Wireless Commercial Keypad comes with one 9V Lithium battery, Wireless Commercial Keypads are security keypads and should be programmed to